13
VSP |
HOW TO DISPLAY THE OPERATING PARAMETERS
• With VSP running (GREEN Display) press the keys
or to display the various operating parameters on the alphanu-
merical display.
• Press the key to return to the initial system pressure display..
• The VSP basic operating parameters are set by default at certain values.
• In this section, only the SYSTEM PRESSURE parameter can be edited. The other parameters are display.
RUN
PREX 4,2
SYSTEM PRESSURE
Pressure measured on the system
RUN
FREQ 43,4
WORKING FREQUENCY
Instantaneous working pressure of the motor
RUN
CURRENT 3,2
ABSORBED CURRENT
Motor absorbed instantaneous current
ATTENTION: reading the input and output currents of the inverter, carried out with
common measurement tools (e.g. clamp meter without TRUE EFFICIENT VALUE), may
result as being incorrect.
RUN
COSFI 0,59
POWER FACTOR (cos φ)
RUN
TEMP.MOD 24
POWER MODULE TEMPERATURE
Temperature of power electronic module of the inverter
RUN
VOLTAGE 224
MAINS VOLTAGE
Mains voltage with which inverter is powered
SYSTEM PRESSURE CHANGE (SETPOINT)
• With keys
and move on the display
RUN
PREX 4,2
• To increase by 0.1 bar, rstly press the key and keeping it pressed, then press the key
For example
SETPOINT 4,2
à + à
SETPOINT 4,3
• To decrease by 0.1 bar, rstly press the key
and keeping it pressed, then press the key
For example
SETPOINT 4,3
à + à
SETPOINT 4,2
To Next Page
Loading...
