5. Make sure the latch strap is threaded at
against the base.
6. Tighten the base against the seat by
pulling the free end of the latch strap.
Press down on the base with your body
weight and tighten further. Check the
level indicator. If the ball has moved into
the red area, turn the knob until the ball
is in the green area. You may need to
loosen the strap slightly to do this. Push
and pull on the base. If you can move
it more than one inch, tighten the belt
further.
How to Install the Base Using the LATCH System Continued
To Next Page
Loading...
