- 44 -
Installing The Car Seat In A Vehicle
REAR FACING INSTALLATION USING
UAS SYSTEM (LUAS)
Take the latch strap out of the compartment
under the seat following instruction at page
18,19, 20. Attach the connectors to the anchor
(a - click) on both sides. Push on the seat (b)
and at the same time pull the free end of the
latch strap (c); let the free end of the strap
through the opening so that it is oriented
parallel to the anchor strap as shown in the
picture. Put the upholstery back in place. The
seat is ready for use.
IMPORTANT! WEIGHT AND HEIGHT LIMITS:
do not install by this method for a child
weighing more than 16 kg (35 pounds).
IMPORTANT! ANGLE CHANGE: Check the
angle of the backrest. If a change in position
is necessary, change the angle to the desired
position (d) following instruction at page 22,
making sure that the seat clicks in one of the
available position (1to 6).
Changing angle in rear facing mode, does
not require re-installation of the seat.
Verify that the child restraint is secure. A
secure child restraint will not move more
than 1 inch near the seat belt anchors.
a
b
c
To Next Page
Loading...
