Peg-Perego Primo Viaggio - Forward Facing Installation Using UAS System

- 49 -
Installing The Car Seat In A Vehicle
FORWARD FACING INSTALLATION USING UAS SYSTEM
Open the rear compartment and pull the top tether out.
Unsnap the upholstery in the seating area. Take the latch strap out of the compartment
under the seat and thread the latch strap into the red guides following instruction at page
18, 19, 20.
Attach the connectors to the seat anchors (a - click).
Push on the seat (b) and at the same time pull the free end of the latch strap (c), so to tighten
the seat as much as possible as shown in the picture. In order to pull more eciently, let the
free end of the strap through the opening so that it is oriented parallel to the anchor strap
as shown in the picture.
a
b
c
a
a
a