- 48 -
Installing The Car Seat In A Vehicle
FORWARD FACING MODE PREPARATION
Turn the seat in forward facing mode following the procedure at page 16.
Take the top tether strap out of its compartment and prepare it following the procedure
at page 21.
Make sure that the seat is properly levelled: this seat is designed so that when installed
in a common vehicle seat (15° crease) the backrest angle can be adjusted between 25°
(position 1) and 45° (position 6).
VERTICAL LINE
25°
45°
IMPORTANT! PROPER RECLINING: Make
sure that the seat is not too reclined in
comparison with the child’s age. If the seat is
too reclined, your child will tend to lean out
of the seat to reach for the window. If too
upright, it can cause breathing problems.
To Next Page
Loading...
