- 46 -
Installing The Car Seat In A Vehicle
Press the car seat with force against the vehicle seat (a). At the same time, pull the lap
portion of the belt toward the buckle (b) and the shoulder portion of the belt in the
opposite direction (c). By doing this, pressure force will build up into the car seat, pressing
it against the vehicle seat.
To complete the installation, let the shoulder portion of the belt pass through the lock o
clips, strapping it in place (d).
Lock o clips are used to enhance the stability during normal use. They are not designed
to replace a locking clip.
The installation is complete as shown in the picture (e).
Verify that the child restraint is secure. A secure child restraint will not move more than
1 inch near the seat belt anchors.
b
a
c
d
e
To Next Page
Loading...
