- 52 -
Installing The Car Seat In A Vehicle
Press the car seat with force against the vehicle seat (a). At the same time, pull the lap
portion of the belt toward the buckle (b) and the shoulder portion of the belt in the opposite
direction (c). By doing this, pressure force will build up into the car seat, pressing it against
the vehicle seat.
To complete the installation, let the shoulder portion of the belt pass through the lock o
clips, strapping it in place (d).
Lock o clips are used to enhance the stability during normal use. They are not designed to
replace a locking clip.
Attach the top tether to the suitable anchor (e - click) in the vehicle following the procedure
at page 21. Pull the free end of the strap until it is fully tensioned (f). A loose tether strap will
reduce the safety of the seat in a crash.
The installation is complete as shown in the picture.
a
b
c
d
f
e
To Next Page
Loading...
