What to do if I see an over current error on my Pegasus PP/EX(P)?
If you're encountering an over current error with your Pegasus Controller, switch the power off, address and eliminate the cause of the over current, and then turn the power back on.
Why does my Pegasus PP/EX(P) Controller show a system error?
If a system error is displayed on your Pegasus Controller due to an internal data error, try turning the power off and then on again. If the error persists after resetting, further investigation by PEGASUS SEWING MACHINE MFG. CO., LTD. is required.
How to fix a pressurizing error on a Pegasus PP/EX(P)?
If you get a pressurizing error on your Pegasus Controller because the pressure has exceeded the upper limit of the set pressure range, adjust the applied pressure to bring it within the specified range.
What to do if I get a residual pressure error on my Pegasus Controller?
To address a residual pressure error on the Pegasus Controller, restore the applied pressure to atmospheric pressure and then repeat the zero clear operation.
General| Brand | Pegasus |
|---|---|
| Model | PP/EX(P) |
| Category | Controller |
| Language | English |
To Next Page