Pego ECP200 BASE 2 - Table of Contents

ECP200 BASE 2/4
ENGLISH
INTRODUCTION
Pag. 3 1.1 General
Pag. 4 1.2 Product ID codes
Pag. 4 1.3 Overall dimensions
Pag. 5 1.4 Identification data
INSTALLATION
Pag. 5 2.1 Important information for the installer
Pag. 5 2.2 Standard assembly kit
Pag. 6 2.3 Installing the unit
TECHNICAL CHARACTERISTICS
Pag. 7 3.1 Technical characteristics
WARRANTY
Pag. 8 4.1 Warranty
PARAMETER PROGRAMMING
Pag. 9 5.1 Control panel
Pag. 9 5.2 Frontal keypad
Pag. 10 5.3 LED display
Pag. 11 5.4 General
Pag. 11 5.5 Key to symbols
Pag. 11 5.6 Setting and displaying set points
Pag. 12 5.7 Level 1 programming
Pag: 12 5.8 List of Level 1 variables
Pag. 13 5.9 Level 2 programming
Pag. 13 5.10 List of Level 2 variables
Pag. 15 5.11 Switching on the ECP200 BASE electronic controller
Pag. 15 5.12 Compressor activation/deactivation conditions
Pag. 15 5.13 Manual defrosting
Pag. 16 5.14 Hot gas defrosting
Pag. 16 5.15 Pump down function
Pag. 16 5.16 Password protection
OPTION
Pag. 17 6.1 TeleNET monitoring / supervision system
Pag. 17 6.2 Net configuration with Modbus-rtu protocol
Pag. 18 6.3 ALARM RELAY / RS485 switching
TROUBLESHOOTING
Pag. 19 7.1 Troubleshooting
APPENDICES
Pag. 20 A.1 EC declaration of conformity
Pag. 21 A.2 ECP200 BASE 4 wiring diagram
Pag. 21 A.3 ECP200 BASE 4A wiring diagram
Pag. 22 A.4 ECP200 BASE 2 wiring diagram
Pag. 22 A.5 ECP200 BASE 2A wiring diagram
Pag. 23 A.6 Connection example (1) - ECP200 BASE4 /BASE4A
Pag. 23 A.7 Connection example (2) - ECP200 BASE4 /BASE4A
Pag. 24 A.8 Connection example (3) - ECP200 BASE2 /BASE2A
Pag. 24 A.9 Connection example (4) - ECP200 BASE2 /BASE2A
CHAP. 1
CHAP. 2
CHAP. 3
CHAP. 4
CHAP. 5
CHAP. 6
CHAP. 7