Pego ECP200 EXPERT - User Manual

Questions and Answers

E
eric81Jul 31, 2025
Why is the temperature flashing on my Pego ECP200 EXPERT display?
- L
  lisafranklinJul 31, 2025
  If the temperature shown on the Pego Control Panel display is flashing, it indicates a minimum or maximum temperature alarm. This means the temperature inside the cold room has exceeded the minimum or maximum temperature alarm setting. Ensure that the compressor is working properly. It might also indicate that the sensor is not reading the temperature correctly or that the compressor start/stop control is malfunctioning.
A
Alan LeblancAug 4, 2025
What to do if my Pego Control Panel displays error 'Ed'?
- J
  Jessica SantosAug 4, 2025
  If the Pego Control Panel shows the 'Ed' error, it indicates an open door alarm. This alarm activates when the door is opened, and after a set time (tdo), the system returns to normal operation, triggering the 'Ed' alarm. To resolve this, check the door switch status and the door switch connections. If the problem persists, further technical assistance may be needed.
L
Lindsay NunezAug 8, 2025
What does error 'Ec' mean on my Pego ECP200 EXPERT Control Panel?
- B
  Bradley HuffAug 9, 2025
  If the Pego Control Panel displays the 'Ec' error, it means the compressor protection has tripped, possibly due to thermal protection or a maximum pressure switch activation. In this case, all outputs except the alarm are deactivated. You should verify that the compressor is functioning correctly and check the compressor absorption. If the problem persists, contact technical assistance.
T
Tyler RamosAug 13, 2025
How to fix error 'E8' on Pego ECP200 EXPERT?
- S
  Samantha StevensonAug 13, 2025
  If the Pego Control Panel is showing error code 'E8', it indicates a 'man in cold room' alarm. To solve this, reset the alarm input inside the cold room.
L
Lauren WoodAug 17, 2025
What does error 'E1' mean on my Pego ECP200 EXPERT Control Panel?
- L
  Logan KaneAug 18, 2025
  If the Pego Control Panel displays error 'E1', it means the defrost sensor is not working properly, which will cause defrosts to last time d3. Check that the defrost sensor is working properly. If the problem persists, replace the sensor.
J
James BarberAug 22, 2025
What does error 'E0' mean on my Pego ECP200 EXPERT?
- K
  Kimberly CopelandAug 22, 2025
  If the Pego Control Panel displays error 'E0', it indicates that the cold room temperature sensor is not working properly. Check that the cold room temperature sensor is functioning correctly. If the problem continues, replace the sensor.
O
owilsonAug 26, 2025
What to do if my Pego ECP200 EXPERT Control Panel displays error 'E2'?
- R
  Ryan LynchAug 26, 2025
  If the Pego Control Panel displays the 'E2' error, it indicates an EEPROM memory alarm. When this alarm is detected, all outputs except the alarm are deactivated. To resolve this, switch the unit off and then back on.