Pego ECP202 EXPERT - User Manual

Other manuals for Pego ECP202 EXPERT

Use And Maintenance Manual24 pages

Questions and Answers

R
Rachel PenaAug 1, 2025
What to do if Pego Control Panel displays error code Ec?
- M
  Mia RossAug 1, 2025
  If the Pego Control Panel displays error code Ec, it indicates that the compressor protection has tripped, possibly due to thermal protection or a max pressure switch. As a result, all outputs except the alarm are deactivated. To resolve this, first, verify that the compressor is functioning correctly and check its absorption. If the problem continues, it's recommended to contact the technical assistance service.
B
bradfordhannahAug 5, 2025
What to do if Pego ECP202 EXPERT displays error code Ed?
- S
  Shane HatfieldAug 5, 2025
  If the Pego Control Panel displays error code Ed, you should first check the status of the door switch and its connections. If the problem persists after checking the switch and connections, contact the technical assistance service.
T
Tracy AtkinsonAug 9, 2025
What to do if Pego ECP202 EXPERT displays error code E1?
- M
  Mr. Tyrone Mays DDSAug 9, 2025
  If the Pego Control Panel displays error code E1, it means the defrost sensor isn't working properly, which will cause defrosts to last time d3. You should check that the defrost sensor is working correctly. If the problem continues, replace the sensor.
M
melissa37Aug 13, 2025
What to do if Pego Control Panel displays error code E0?
- A
  Alvin MillerAug 13, 2025
  If the Pego Control Panel displays error code E0, it indicates that the cold room temperature sensor is not working properly. First, check that the cold room temperature sensor is functioning correctly. If the issue continues, you should replace the sensor.
L
Latoya GentryAug 18, 2025
What to do if my Pego ECP202 EXPERT Control Panel displays error code E2?
- S
  Samantha VargasAug 18, 2025
  If the Pego Control Panel displays error code E2, switch the unit off and then back on.
K
Katrina HamptonAug 22, 2025
What to do if my Pego Control Panel displays error code E8?
- M
  michaelmarshAug 22, 2025
  If the Pego Control Panel displays error code E8, reset the alarm input inside the cold room.
K
kelsey31Aug 27, 2025
What to do if my Pego Control Panel displays error code E9?
- D
  Derek DavisAug 27, 2025
  If the Pego Control Panel displays error code E9, turn off the light.