Why does my Pelgrim GVWC270L have grease deposits?
Grease deposits in your Pelgrim dishwasher are often caused by prolonged use of low temperature programs. Select a program with a high temperature to dissolve grease on very dirty dishes, such as Intensive 70°.
Why are my dishes not clean in my Pelgrim Dishwasher?
There are several reasons why your dishes might not be clean. The spray arms may be blocked by dishes, or the spray arm holes or bearings could be blocked, requiring cleaning. You might be using an unsuitable dishwashing program; try a high-temperature program like Intensive 70° for greasy dishes. Incorrect detergent dosage, old detergent, or dishes loaded incorrectly can also cause this problem. Make sure not to cover dishes with large bowls and avoid placing tall glasses in the corners. Glasses and cups should be placed to sit steady. Also, check if the filters are clogged or not fitted correctly, and ensure the yellow drainage pump stop is in place.
Why does my Pelgrim GVWC270L have spots or films on the dishes?
Spots or films on dishes in your Pelgrim dishwasher can be due to an incorrect rinse aid dosage setting. Check the rinse aid dosage setting. If the TAB setting is activated and you are using all-in-one detergent with insufficient drying effect, switch to separate detergents or deactivate the TAB setting and top up with salt and separate rinse aid. Also, check if the salt compartment is empty and top up with salt if needed. Finally, verify that the water softener setting is correct.
What to do if detergent residue remains in the detergent compartment of my Pelgrim Dishwasher?
If there's detergent residue in the detergent compartment of your Pelgrim dishwasher after washing, ensure that the detergent compartment was dry when you added the detergent. Also, check that the dishes are not preventing the detergent compartment from opening.
Why does my Pelgrim Dishwasher make a rattling sound?
A rattling sound during dishwashing in your Pelgrim dishwasher indicates that the dishes are not correctly placed or the spray arms are not rotating. Check that the dishes are placed securely and spin the spray arms to make sure they can rotate freely.
Why does my Pelgrim GVWC270L Dishwasher have a sticky white/blue film on the dishes?
A sticky white/blue film on the dishes from your Pelgrim dishwasher usually means the rinse aid dosage setting is too high. Reduce the dosage. If you have very soft water, you may want to dilute the rinse aid 50:50 with water.
Why does my Pelgrim GVWC270L have spots left after washing?
If your Pelgrim dishwasher leaves spots after washing, it may be because lipstick and tea can be difficult to wash off. Use a detergent with a bleaching agent.
Why does the control panel of my Pelgrim GVWC270L Dishwasher not react when pressed?
If the control panel of your Pelgrim dishwasher does not react when pressed, wait a moment and try again. The control panel only reacts to use when the door is open. If this doesn't work, clean the control panel with a dry or slightly damp cloth.
What to do if the water softener is leaking salt in my Pelgrim Dishwasher?
Check that the salt compartment lid is properly tightened.
How to fix F10 error on Pelgrim GVWC270L Dishwasher?
To fix the F10 error on your Pelgrim dishwasher, unblock the drainage pump.
General| Type | Freestanding |
|---|---|
| Noise level | 49 dB |
| Drying Class | A |
| Width | 60 cm |
| Height | 85 cm |
| Depth | 60 cm |
To Next Page
