pellenc EXCELION 2 LH - Page 32

BRUSH CUTTER EXCELION 2 LH
53_154421-A
13. Using the special EXCELION 2 wrench (23) supplied
with your tool, tighten the nut anti-clockwise while
holding the protective bowl.
Tightening torque: 35 N m.
Note
After fitting your cutting head on your tool, it is nec-
essary to select it in the HMI to operate the tool. Re-
fer to Section 5.5.2, “Activation of the cutting head
via the HMI menu”.
Removing the chisel-saw blade
1. Using the special EXCELION 2 wrench (23) supplied
with your tool, unscrew the nut clockwise while hold-
ing the protective bowl.
2. Remove in turn:
• the protective bowl,
• the chisel-saw blade (ref. 111700).
Removing the cutting head
1. Unscrew the two screws on the angle gear.
2. Remove the screw located on the right side of the
angle gear.
32