To Next Page
M
Meghan OrtizJul 31, 2025
Why my pellenc EXCELION 2 DH does not start?
- RRyan BakerJul 31, 2025
There are several reasons why your Pellenc Brush Cutter might not be starting. It could be due to the battery being off—ensure it's switched on and the pictogram is displayed on the battery HMI screen. Other potential causes include a severed or incorrectly connected power cord (replace the cord or connect the quick connector), a discharged battery (recharge it), a faulty electronic circuit board (replace the board if the HMI screen remains off after checking the previous points), or a malfunctioning trigger (replace the trigger or sensor).
General
