pellenc EXCELION 2 DH - Transporting the Tool; Storing the Tool

BRUSH CUTTER EXCELION 2 DH
53_153238-A
8.2. TRANSPORTING THE TOOL
Important
• Never carry the machine or the battery by the power cord.
• Switch off the tool (see Section 5.1.2, « Stopping the tool »).
• Disconnect the battery (see Section 4.6, « Disconnecting the battery »).
• Put the tool in the storage position (see Section 8.1.1, « Tool storage position »).
• Make sure that the packed machine and battery are properly secured in the transport vehicle.
8.3. STORING THE TOOL
Important
• In the event of prolonged storage, grease the output shaft of the angle gear (refer to Section 6.5, « Angle
gear lubrication »).
• Always make sure the tool is clean and its battery is charged before storing it.
• The Brush cutter Excelion 2 DH must be stored away from heat, dust and humidity at an ambient temperature
between 0° C and 40° C.
• The machine and the battery must be stored in their original packaging, in a dry place and out of the reach
of children.
The Brush cutter Excelion 2 DH is equipped with an at-
tachment point (17) which allows the tool to be suspen-
ded against a wall.
In the case of a first installation:
1. Install at a height of 1.90 metres from the ground:
• either a screw whose head is at least 5 mm high
and has a head diameter of less than 10 mm.
• Or a hook whose diameter is less than 5 mm.
Note
The attachment point should protrude 25mm
from the wall.
Use screws suitable for the material that com-
poses your wall.
2. Hang the Brush cutter on the wall by its attachment
point.
76