BRUSH CUTTER EXCELION 2 DH
53_153238-A
4.4.4. ADJUSTING THE LENGTH OF THE STRIMMER WIRE ON TAP CUT 2 AND 3
Adjustment of the length of the strimmer wire
1. Start the tool (refer to Section 5.1.1, « Power on »).
2. Operate at maximum speed.
3. Gently tap a few times on the ground.
The strimmer wire length will be gradually adjusted by
cutting itself on the blade of the safety guard.
4.4.5. FITTING/DISMOUNTING THE CHISEL-TOOTH SAW ON THE TOOL
Note
Refer to part Section 9.1.3, « Chisel-tooth saw » for the description and part numbers of accessories.
Attention
Before any intervention on the tool, stop the machine completely and disconnect the battery. To
consult the procedure for switching off your tool, refer to Section 5.1.2, « Stopping the tool ».
Wear safety gloves. Handling of sharp elements.
32
To Next Page
Loading...
