BRUSH CUTTER EXCELION 2 DH
53_153238-A
Maintenance task
At each
start-up
Eve-
ry two
hours
Every 50
hours
Every
month
After
each use
Every
year or
as ne-
cessary
Visual check of the air exhaust screen and the
air intake screen which must not be obstructed
X
Functional check of the safety throttle X
Sharpening verification and re-sharpening if ne-
cessary
X X X
Visual inspection of the cutting tool (no cracks
or deformation)
X X X
Visual inspection of the cutting tool's attachment
to the shaft (absence of distortion or wear and
tear)
X X X
Verification of the wear and tear of the notched
cam teeth and sharpening if necessary or repla-
cement of the notched cam
X X X
Check the battery level X
Machine check by an approved PELLENC dea-
ler
X
Angle gear lubrication X
Lubrification of the CITY CUT blades X
Cleaning the CITY CUT blades X
Greasing the angle gear of the CITY CUT X
Important
Have the machine serviced every 400 hours or at least once a year by an authorised PELLENC distributor.
6.3. CLEANING THE TOOL
After each use, clean with water:
Avertissement
Do not use a high pressure cleaner.
• The safety guard (13).
Note
If necessary remove the safety guard (see Sec-
tion 4.3, « Fitting/ dismounting of the safety
guards on the Brush cutter »).
• The cutting head (12).
64
To Next Page
Loading...
