pellenc EXCELION 2 LH - CITY CUT FITTING;DISMOUNTING

BRUSH CUTTER EXCELION 2 LH
53_154421-A
3. Take the tool transmission shaft (14) out of its hous-
ing.
4. Remove the cutting head.
4.4.6. FITTING/DISMOUNTING THE CITY CUT ON THE TOOL
Caution
Before any intervention on the tool, stop the machine completely and disconnect the battery. To
consult the procedure for switching off your tool, refer to Section 5.1.2, “Stopping the tool”.
Wear safety gloves. Handling of sharp elements.
Fitting
1. Unscrew the two screws on the angle gear (11)
mounted on the tool.
2. Take the transmission shaft (14) out of its housing.
3. Remove the angle gear (11).
4. Unscrew the two screws on the CITY CUT using the
TORX 25 (22) wrench supplied with your tool.
33