pellenc EXCELION 2 LH - Dismounting;Fitting of the City Cut Safety Guard; Maintenance of the City Cut

BRUSH CUTTER EXCELION 2 LH
53_154421-A
6.6.2. DISMOUNTING/FITTING OF THE CITY CUT SAFETY GUARD
Dismounting
1. Using a T20 screwdriver, unscrew the 4 screws
holding the safety guard in place.
2. Remove the casing.
Fitting
1. Position the safety guard behind the angle gear.
2. Using a T20 screwdriver, tighten the 4 screws hold-
ing the safety guard in place.
6.7. MAINTENANCE OF THE CITY CUT
6.7.1. DISMOUNTING/FITTING OF THE CITY CUT SAFETY GUARD
Dismounting
1. Dismount the CITY CUT (refer to the "dismount" part
of Section 4.4.6, “Fitting/dismounting the CITY CUT
on the tool”).
2. Using a T20 screwdriver, unscrew the 2 screws
holding the CITY CUT safety guard in place.
3. Remove the 2 parts of the safety guard.
Fitting
1. Fit the 2 parts of the safety guard.
2. Using a T20 screwdriver, tighten the 2 screws hold-
ing the CITY CUT safety guard in place.
3. Refit the CITY CUT cutting head onto the tool (refer
to the "assembly" part of Section 4.4.6, “Fitting/dis-
mounting the CITY CUT on the tool”).
63