PV 20a
Safety precautions
Do not start the burner before it is connected to the boiler and the boiler is connected to the
chimney.
It is recommended to wear a respirator while handling pellets.
The boiler room where the burner is installed must fulfill all rules and recommendations given by
authorities.
All electrical connections must be done by trained professionals.
No flammable materials must be stored near the burner.
Warnings
Changing the construction of the burner without written permission from the
manufacturer is forbidden.
Use only spare parts provided or approved by the manufacturer in order to avoid
any damage to the burner and dangers resulting from it
Welding is allowed only after disconnecting the burner from electric supply. The
circuit board must be removed from the burner.
Do not open any boiler door while the burner is in operation.
The burner complies with following directives and standards
Directive 2004/108/EC
Directive 2006/95/EC
Directive 2001/95/EC
Directive 2006/42/EC
EN 15270 2008
EN 230 2005
EN 60370-2-5 2002
3 www.pelltech.eu
To Next Page
Loading...
