Pelpro PP130-B - Glass Specification

PelPro Pellet Stove • 7104-171A • 4/20/18
pelprostoves.com32
Listing and Code Approvals
Listings and Certications
Glass Specications
This Stove is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact PelPro for replacement glass.
Electrical Rating (On High)
PP130-B: 120 VAC, 60 Hz, Start 2.6 Amps,
Run 2.3 Amps
* Weighted average HHV efciency using data collected during EPA emissions test.
**BTU input/output will vary, depending on the brand of fuel you use in your Stove.
**Heating capacity depends on climate zone, structure layout, insulation, windows, etc.
This manual describes the installation
and operation of the Brand PelPro,
Model PP130-B wood Stove.
This Stove meets the 2020 U.S.
Environmental Protection Agency’s
crib wood emission limits for wood
Stoves sold after May 15, 2020. Under
specic test conditions this Stove has
been shown to deliver heat at rates
ranging from 9,605 to 40,637 Btu/hr.
BTU & Efciency Specications
Model PP130-B
Emissions Report
No.
0135PS041E
EPA Certied 0.53 grams/hr
*HHV Tested
Efciency
81.9%
**BTU Input 11,676 - 49,207 / hr
***Heating
Capacity
750 to 1,450 sq. ft.
depending on climate zone
Vent Size 3” or 4” L or PL
Hopper Capacity 130 lbs (Approximate)
Fuel Wood pellets
Shipping Weight xxx lbs
2-1/2
[64]
4-1/2
[114]
24-1/2 [622]
36-1/2 [902]
24-1/2 [622]
22-3/4 [578]
8-1/4 [210]
AIR INLET
9-1/2 [241]
FLUE
104 of 112