Pelpro PP130-B - Comfort Settings

PelPro Pellet Stove • 7104-171A • 4/20/18
pelprostoves.com18
Using Your Stove
Using Your Stove
Comfort Settings
Control your comfort with a single dial:
• OFF setting - Used to turn your Stove off
• LO setting – Your Stove will continue to run on low
regardless of room temperature. LED light will be steady
amber
• 1 through 10 settings – Set to your desired comfort
level. Once the desired comfort level is achieved
the Stove will automatically shut down. When the
temperature in the room drops below the desired
comfort level, your Stove will automatically restart.
2
1
4
3
5
6
7
8
9
10
LO
OFF
HI
0
-
1
-
2
-
3
-
4
+
1
+
2
+
3
+
4
O
N
A
U
T
O
A
L
A
R
M
2
1
4
3
5
6
7
8
9
10
LO
OFF
HI
Pro Tip
If the dial control is turned to the off position and then back on, even if by mistake, your
Stove will go through the shutdown process (approximately 15 minutes) and restart.
Thermostat
Your PelPro Stove comes with a built-in thermostat system that provides easy
temperature adjustments. The Stove is not designed to use a remote control or
external thermostat.
Trim
Adjustment
• HI setting - Your Stove will continue to run on high regardless of room temperature. LED light will
be steady amber.
Trim Adjustment
Trim adjustment is the small dial located below the main dial control. Rotating this dial will adjust the
air/fuel ratio and below are examples of when to use it:
• If the re is too large, lazy or producing black soot, rotate the dial counterclockwise one level at a
time and allow 15 minutes for stabilization before making another adjustment
• If your re is too small and sometimes goes out when there are pellets in the hopper, rotate the
dial clockwise one level at a time and allow 15 minutes for stabilization before making another
adjustment.
90 of 112