Pelpro PP130-B - Troubleshooting; Power and Component Issues

PelPro Pellet Stove • 7104-171A • 4/20/18
pelprostoves.com24
Troubleshooting
Troubleshooting
Pro Tip
Check passages to
assure they are clear of
ash and obstructions.
Poor airow leads to
poor performance of
your Stove.
Troubleshooting your Stove
Visit pelprostoves.com or scan the code:
A
1
Zone
1
Zone
3
Zone
3
Zone
2
Zone
2
Zone
Power Related
In the event of a power outage:
• If using a generator, PelPro recommends
a steady state generator for best Stove
performance.
• This Stove needs 110v to run properly. This
Stove has not been tested for use with a third
party battery backup.
Stove plugged in but no response
• Unplug your Stove
• Check your home’s circuit breaker
• Reset snap disc (located between drop tube and
hopper (Zone 2)
• Visually inspect wires, blowers and power cord
for breaks or wear to nd cause of possible short
circuit (Zone 2)
Component (i.e. blower) fails to start or fails to
turn off
• Unplug your Stove
• Check all connections and power plugs are secure
• Visually inspect wires, blowers and power cord to
nd cause of possible short circuit



A
96 of 112