Model: PP 130-B
Hearth & Home Technologies
352 Mountain House Road
Halifax, PA 17032
QUALITY ASSURANCE/QUALITY CONTROL
OMNI follows the guidelines of ISO/IEC 17025, “General Requirements for the Competence of
Testing and Calibration Laboratories,” and the quality assurance/quality control (QA/QC)
procedures found in OMNI’s Quality Assurance Manual.
OMNI’s scope of accreditation includes, but is not limited to, the following:
• ANSI (American National Standards Institute) for certification of product to safety
standards.
• To perform product safety testing by the International Accreditation Service, Inc.
(formerly ICBO ES) under accreditation as a testing laboratory designated TL-130.
• To perform product safety testing as a “Certification Organization” by the Standards
Council of Canada (SCC).
• Serving as a testing laboratory for the certification of wood heaters by the U.S.
Environmental Protection Agency.
This report is issued within the scope of OMNI’s accreditation. Accreditation certificates are
available upon request.
The manufacturing facilities and quality control system for the production of the PP130-B at
Hearth and Home Technologies were evaluated to determine if sufficient to maintain
conformance with OMNI’s requirements for product certification. OMNI has concluded that the
manufacturing facilities, processes, and quality control system are adequate to produce the
appliance congruous with the standards and model codes to which it was evaluated.
This report shall not be reproduced, except in full, without the written approval of OMNI-Test
Laboratories, Inc.
To Next Page
Loading...
