Pelpro PP150 - Blockage and Noise Issues; Ignition and Startup Problems

PelPro Pellet Stove • 8104-171B • 10/21 PelPro Pellet Stove • 8104-171B • 10/21pelprostoves.com pelprostoves.com36
37
Listing and Code Approvals Listing and Code Approvals
Listings and Certications
Mobile Home Approved
This Stove is approved for mobile home
Installations when not installed in a sleeping room and when an outside combustion air inlet is provided.
• The structural integrity of the mobile home oor, ceiling, and walls must be maintained
• The Stove must be properly grounded to the frame of the mobile home with #8 copper ground wire, and use
only listed double-wall connector pipe
• Outside Air Kit provided with each Stove must be installed in a mobile home installation and must remain
clear of leaves, debris, ice and/or snow. It must be unrestricted while the Stove is in use to prevent room air
starvation which causes smoke spillage.
• The Stove must be secured to the mobile home structure by bolting it to the oor through holes provided at
bottom of your cast legs on your Stove.
WARNING! Asphyxiation Risk.
DO NOT INSTALL IN A SLEEPING ROOM. Your Stove consumes
oxygen in the room.
Note
This installation must conform with local codes.
In the absence of local codes you must comply with ASTM E1509-12 and ULC S627-00 and (UM) 84-HUD
WARNING!
• It is critical to have a working smoke detector installed in the home of Stove operation.
• Smoke alarms that are properly installed and maintained play a vital role in reducing re deaths and injuries. Having a
working smoke alarm reduces the chance of re related injuries.
• Install at least one carbon monoxide detector on each oor of your home.
Stove Certication
Series
PP150
Laboratory
UL LLC
Safety Report
No.
MH60687
Type
Solid Fuel Room Stove/Pellet Fuel Burning Type
Standard
ASTM E1509-12 and ULC S627-00, Room Stove
Pellet Fuel Burning type and (UM) 84-HUD, Mo-
bile Home Approved.
Note
This wood stove needs periodic inspection and repair for proper operation. It is against
federal regulations to operate this wood heater in a manner inconsistent with operating
instructions in this manual.
Listings and Certications
Glass Specications
This Stove is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact PelPro for replacement glass.
Electrical Rating (On High)
PP150: 120 VAC, 60 Hz, Start 2.6 Amps,
Run 2.3 Amps
BTU & E󰀩ciency Specications
Emissions Report No. 0135PS041E
EPA Certicatin # Number: 128-18
EPA Certied 0.53 grams per hour
*LHV Tested E󰀩ciency 87.5%
**HHV Tested
E󰀩ciency
81.9%
***BTU Output 9,605 to 40,667 / hr.
****BTU Input 11,676 to 49,207 / hr.
*****Heating Capacity
1,225 to 2,500 sq. ft.
depending on climate zone
Vent Size 3” or 4” L or PL
Hopper Capacity 150 lbs (Approximate)
Fuel Premium Wood pellets
Shipping Weight 275 lbs
(64)2-1/2
(114)4-1/2
(622)24-1/2
(978)38-1/2
(581)22-7/8
(243)
FLUE
9-1/2
(210)
AIR INLET
8-1/4
Stove dimensions
*Weighted average LHV e󰀩ciency using data collected during EPA emissions test.
**Weighted average HHV e󰀩ciency using data collected during EPA emissions test.
***Maximum BTU output based on HHV e󰀩ciency and the high burn section of the EPA emissions test.
****Maximum BTU input based on the high burn section of the EPA emissions test.
*****Heating capacity depencs on climate zone, structure layout, insulation, windows, etc.
Stove Dimensions
The PP150 is
Certied to comply
with 2020 particulate
emission standards.