PT395 Series Detector
Resetting Alarms
If the alarm relays are configured as Non-Latching then the relays will be
deactivated once the alarm level falls below the pre-set level. Else the relay must
be deactivated manually by using the magnetic wand as shown in figure 10
below
Hold the magnet to its place for few seconds until the transmitter displays “RST”
on the LCD. Move the magnet away. The relays will be de-energized, however,
if the gas concentration continues to be above the alarm level the relays will be
activated again.
Figure 10. Magnetic switch position 4 o'clock to RESET alarms and to adjust alarm set points
Magnetic Wand
Low
High
Fault
To Next Page
Loading...
