instrument will wait for a pending measurement to finish before outputting a zero result. The range is 10 ms
to 1000 s.
Interpolatator Calibration: By switching off the interpolator calibration, you can increase the measurement
speed at the expense of accuracy.
TIE (CNT-91 only): From a submenu you can either let the counter choose the reference frequency
automatically (Auto) or enter it manually.
Math/Limit
Fig. 2-23 Selecting Math or Limits parameters.
You enter a menu where you can choose between inputting data for the Mathematics or the Limits postprocessing unit.
Fig. 2-24 The Math submenu.
The Math branch is used for modifying the measurement result mathematically before presentation on the display. Thus
you can make the counter show directly what you want without tedious recalculations, e.g. revolutions/min instead of
Hz.
The Limits branch is used for setting numerical limits and selecting the way the instrument will report the measurement
results in relation to them.
Let us explore the Math submenu by pressing the corresponding softkey below the display.
30 / 50
To Next Page
Loading...
Need help?
General
