22
2. Close and lock the door.
3. Press the Tub Fill Button and turn the Temperature Control
Knob all the way to the left to its warmest level to heat the
disinfectant solution and maximize its effectiveness.
4. Remove any visible tissue, residue, or fluids from the tub by
pressing the Shower Button and rinsing the inside tub surfaces
with the shower sprayer.
5. Press the Fill Button again to turn off the water. Allow the tub to
drain, and place the drain plug over the drain.
On the Aqua-Aire® Tubs, press and hold the Disinfect Jets Button located
on the left side of the tub. As the button is held down, the properly mixed
cleaning solution is running through the air injection system and out all of
the air jets. Release the button after you see solution coming out of all the
air jets and you have 1 to 1 1/2 gallons of disinfectant solution in the foot
well of the tub.
WARNING
Housekeeping personnel should wear protective glasses and gloves
to prevent disinfectant from damaging their eyes or skin. If
disinfectant gets on the skin or in the eyes, rinse thoroughly with
plenty of water. Seek medical advice if irritation occurs.
6. Using the long-handled brush, available from your Penner
distributor, thoroughly scrub all interior surfaces of the tub, and
Swivel Lift with the solution that remains in the foot well of the
tub. Let disinfectant stay on surface for 10 minutes. (Or, as
recommended by the instructions on the disinfectant
concentrate container.)
7. Remove the plug from the drain.
8. Rinse the Swivel Lift and the tub’s interior surfaces thoroughly
with the shower sprayer.
9. Press and hold the Rinse jets button located on the left side of
the control panel until clear water runs from all the air jets. Then
release the Rinse jets button.
10. Finish rinsing the Cascade™ Swivel Lift Bathing system and
the interior surfaces of the tub with the shower sprayer.
To Next Page
Loading...