Penner Manufacturing Cascade - Transferring Patient Out of Tub; Warning: Drain Tub Before Unlocking Door

20
Transferring Out Of Cascade™ Swivel Lift Bathing
System
After the bath has been given, you are now ready to transfer the
resident out of the tub.
1. Drain the tub by pulling the drain plug (Figure 1) from the
drain. Allow the tub to be drained completely.
WARNING
Failure to have the tub completely drained before
unlocking the door could cause injury to the operator and
resident.
2. Unlock door by pulling up on the door handle release, and
pulling up on the lever at the same time.
3. Open door to widest position.
4. Dry off resident.
5. Raise the Swivel lift completely.
6. Rotate or Swing resident completely out of the tub
7. Lower the Swivel Lift completely.
8. Insure the floor has a non-slip surface before removing the
resident from the Cascade™ bathing system and that the floor
is not wet.