EasyManua.ls Logo

Penner Manufacturing Cascade - Post-Bath System Cleaning; Exit Safety: Floor Surface; Caution: Approved Cleaning Agents

Penner Manufacturing Cascade
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
WARNING
Failure to insure the floor, near the entry of the Cascade™
Bathing System, has a non-slip surface could result in injury to
the operator or patient.
9. With resident secure, remove the belting from the resident.
10. Use proper nursing techniques to transfer to a wheelchair or
other chair.
11. If using a sit-to-stand lift or total lift, follow the manufacturer’s
instructions on the use of that particular lift.
12. After finishing your post bath routine, take the resident out of
the bathing room.
13. You are now ready to disinfect the Cascade™ Tub.
System Cleaning (After Every Bath)
Clean and disinfect the tub and swivel lift after every bath with Penner
Cleaner/Disinfectant as follows:
Note: Penner Cleaner/Disinfectant is a special non-abrasive
cleaning and disinfecting solution that will not harm the tub’s
fiberglass surface. Penner Cleaner/Disinfectant is the only cleaning
solution designed and recommended for use with your Cascade™
Tub.
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Some cleaners, disinfectants, and floor strippers contain
ingredients that are corrosive or abrasive. These solutions or
compounds may contain chlorine, acid, basic ingredients or
abrasives. DO NOT allow such solutions or compounds to
come in contact with your Penner equipment. Failure to heed
this caution could result in damage to the equipment and void
the warranty.
1. Raise the Cascade™ Swivel Lift completely and rotate or swing
the chair back into the tub.