23
11. Start the air blower by pushing the Aqua-Aire® Button. Allow it
to run for 30 seconds. This pushes the rinse water out of the air
injection system. If this was the last bath of the day, allow the
blower to run for 2 minutes to dry out the system.
12. Stop the Aqua-Aire® blower by again pushing the Aqua-Aire®
button.
13. Visibly check that the tub and reservoir (if applicable) was
effectively cleaned during the disinfecting procedure. If not,
repeat the procedure.
14. If there is a delay of one or more hours before the next bath, we
recommend using a towel to wipe off all excess water. This will
keep your Cascade™ Tub looking great for years to come.
The lid of the reservoir can be removed to allow access for
cleaning and disinfecting when necessary.
Daily Maintenance
To properly maintain the Cascade™ Swivel Lift Bathing system,
perform the following daily maintenance procedures.
1. Check that there is an adequate supply of system liquids such
as shampoo, bath oil, and disinfectant concentrate in the supply
bottles located behind the small access door on the left side of
the tub. Replace the bottles before they are empty to avoid re-
priming the system. Be sure each bottle label matches the
label found on the hose to which the bottle is attached.
WARNING
While replacing system liquids, housekeeping personnel should
wear protective glasses and gloves to prevent disinfectant
concentrate from damaging their eyes or skin. If disinfectant
gets on the skin or in the eyes, rinse thoroughly with plenty of
water. Seek medical advice if irritation occurs.
2. Perform the Daily Safety Checklist described in the following
section before using the system.
Reservoir Cleanin
To Next Page
Loading...