EasyManua.ls Logo

Pentair CHLORPLUS PROTECT 10 - Installation; Installation Continued; Filter Cartridge Replacement; Filter Cartridge Replacement Steps

Pentair CHLORPLUS PROTECT 10
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION CONTINUED
4. [H] 



NOTE: Approximately 6" will be


[I] 


5. [J] Slip brass compression nut 
[K]
pipe.
[L] 

6. [M] 


water supply [N]. It will be necessary






NOTE: If using mounting bracket, be
sure to slip bracket over screws in wall
(see step 2).
7. [O] Slowly turn on water supply to allow
[P] 


[Q] 

CAUTION:
If water pipes are used to
ground electrical systems, appliances,
or phones, be sure to install a jumper

with any questions about your home’s
electrical system.
FILTER CARTRIDGE REPLACEMENT
WARNING:
Use safety glasses when
handling household bleach to prevent
bodily injury. Follow bleach manufacturers
instructions when handling bleach.
A. [1] 

NOTE:
within the household. Fill a bucket with
water to clean housing after it has been
removed.
[2]
to release pressure.
[3]
turning clockwise.
B. [4] 


[5] 





[4] 



NOTE: This step is important to ensure
proper housing seal. Make sure the
O-ring is seated level in the groove.
[5] 

C. [6] 
DO NOT
OVERTIGHTEN. Make certain cap

[7]


[8] 




MAINTENANCE:



C
6
8
7
NOTE:
For cold water use only
Do not install where system will be exposed to direct sunlight.
Make certain that installation complies with all state and local laws and regulations.

cartridge are not necessarily in your water. Ask your local water municipality for a copy
of their water analysis, or have your water tested by a reputable water testing lab.
After prolonged periods of non-use (such as during a vacation) it is recommended

before using.



Spent adsorption media will not be regenerated and used.
INSTALLATION
NOTE:


For installation on standard 1/2" or 3/4" main water line (galvanized, copper or plastic pipe).


instructions on p.4 before proceeding with installation. See Filter Cartridge Selection
Guide

Numbered diagrams correspond with numbered steps.
1. [A][B] to release pressure in pipes

[C]


2. [D] 

mark screw locations on wall. Insert
mounting screws into wall.
[E] 




ports.
NOTE:

changes.
3. [F] 

DO NOT
OVERTIGHTEN

[G] 

NOTE: If using mounting bracket, be


2 3 4
PENTAIR CHLORPLUS PROTECT 10 SYSTEM • INSTALLATION AND OPERATION INSTRUCTIONS
A
2
3
1
B
4
5
1
A
B
C
3
F
G
E
D
2
4
H
I
5
J
K
L
6
N
M
7
O
Q
P

Related product manuals