COLORVISION Light Installation and User’s Guide
6
Note: Prepare the end of the
ColorVision light power cable and
install to the 12 VAC output wires of an
approved transformer (if you are using
longer runs of cables or multiple lights
per transformer, it is recommended to
use the 13 VAC or even the 14 VAC tap
on your transformer).
WATER LEVEL
NICHE
Water Depth
2” to 12” (5 - 30.5 cm)
PLASTER
1” (2.54 cm) PVC
(For electrical)
Conduit
GUNITE
1-1/2 (3.81 cm) Schedule 40 PVC
GUNITE
Figure 2.
INSTALLING THE COLORVISION™ LIGHT NICHE
IN A GUNITE/CONCRETE POOL
(AFTER ELECTRICAL REQUIREMENTS ARE MET)
Figure 1.
1. Install the O-ring on the gunite cover and install the gunite cover over the top
of the niche using the supplied machine screws, see Figure 2. This will protect
the light cavity of the niche during installation. Secure the gunite cover with
the eight (8) 8-32 x 1/2” machine screws (provided), see Figure 2. Using a No.
2 Philips head screwdriver, tighten each retaining screw to a torque value of
10.00 (minimum) to 15.0 (maximum) in-lbs to secure the gunite cover on the
niche. DO NOT OVER TIGHTEN THE SCREWS. DO NOT ASSEMBLE WITH
POWER TOOLS. Over tightening or using a motorized screwdriver on the
gunite cover screws can over torque the screw threads and damage the niche
housing and/or gunite cover.
Note: Cover the mounting screws with tape to prevent concrete and
plaster from entering the holes. Note: If a gunite cover is not available,
use masking tape to protect the light cavity from the plaster operation.
Machine screws
(QTY. 8 - provided)
To Next Page
Loading...
Need help?
General
