COLORVISION Light Installation and User’s Guide
COLORVISION Light Installation and User’s Guide
3
Selecting a ColorVision Light Show Mode or Fixed Color Using
a Wall Switch
ColorVision lights are compatible with IntelliBrite light colors and shows and can be
synchronized with IntelliBrite
®
lights. First switch power on to the light; the previously
selected color is displayed, unless the HOLD or RECALL feature was previously
enabled.. To select a color show mode (1-7) or fixed color (8-12), turn the wall switch
Off/On a specific number of times. Each number (1-15) shown below corresponds to
the number of times to power-cycle the switch to activate a color light show or fixed
color. For details about saving color effects while in Show modes, see “Hold” and
“Recall” feature on page 6.
1 SAm Mode: Cycles through white, magenta, blue and green colors
(emulates the Pentair SAm
®
Color Light).
2 Party Mode: Rapid color changing building energy and excitement.
3 Romance Mode: Slow color transitions creating a mesmerizing and
calming effect.
4 Caribbean Mode: Transitions between a variety of blues and greens.
5 American Mode: Patriotic red, white and blue transition.
6 California Sunset Mode: Dramatic transitions of orange, red and
magenta tones.
7 Royal Mode: Richer, deeper color tones.
8 Blue: Fixed color.
9 Green: Fixed color.
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
13 Hold: Save the current color effect during a color light show.
14 Recall: Activate the last saved color effect.
15 White
Number of times to cycle power (1-17)
Example: To select California Sunset Mode; First switch power on to the light; the
previously selected color is displayed, unless the HOLD or RECALL feature was
previously enabled, then turn the switch off and on six (6) successive times. During the
Off/On switching process, no illumination will occur.
To Next Page
Loading...
Need help?
General
