COLORVISION Light Installation and User’s Guide
COLORVISION Light Installation and User’s Guide
7
1. Cut a six inch hole in the desired location for the ColorVision light
niche.
2. The niche may be attached to the fiberglass using marine grade
epoxy or silicone or may be mechanically fastened per the
instructions below.
3. Place and center the face ring over the cut hole in the fiberglass
and mark the mounting screw locations and drill screw clearance
holes with a 3/16” drill bit.
4. Place the sealing gasket on the niche and align the gasket screw
holes with the niche as shown below.
5. Insert the niche through the six inch hole in the pool wall.
6. Install a sealing gasket on top of the fiberglass, aligning the screw
holes on the niche as shown below.
Installing ColorVision™ Color Light Niche in a
Fiberglass Pool
To install the ColorVision Color Light niche in a fiberglass pool:
2. Install the ColorVision light niche in the pool or spa floor, see Figure 1
on page 6. Note: The niche is ABS so use ABS to PVC cement to
connect the water line and electrical conduit to the niche.
3. Set the niche in gunite as per current local building codes.
4. Apply plaster up to the outer edge of the gunite cover. The gunite cover
should be the only exposed part of the niche after plastering, see Figure 1
on page 6.
5. After the plastering has been completed, remove and retain the gunite
cover. Retain the screws to fasten the lens into the niche.
Vinyl/Fiberglass ring
Gasket
Pool wall
Gasket
Niche
To Next Page
Loading...
Need help?
General
