COLORVISION Light Installation and User’s Guide
COLORVISION Light Installation and User’s Guide
29
ColorVision
®
Light Accessories Bag Assembly Contents
It is recommended as an initial setup to use the ¾” eyeball. However, you should use the
eyeball size that better suits the flow rate, water depth, and desired plume height. To
increase the plume height, use the smaller eyeball.
Eyeball Assembly Installation and Replacement Instructions
Eyeball Assembly Installation
To install the eyeball assembly:
APPENDIX
ACCESSORIES BAG ASSEMBLY INSTRUCTIONS
1. Insert the eyeball perpendicular
into the slots in the lens
opening.
2. Rotate to center the eyeball into
the lens eyeball housing being
sure the inside lip of the eyeball
is facing up.
To Next Page
Loading...
