COLORVISION Light Installation and User’s Guide
18
13. Install the lens screw cover ring on the lens and twist to lock in place.
12. Install an O-ring on the lens and install the lens over the top of the niche
using the supplier machine screws. Secure the lens with the eight (8) 8-32
x 1/2” machine screws (provided), see Figure 1 on page 6. Using a No. 2
Philips head screwdriver, tighten each retaining screw to a torque value
of 10.00 (minimum) to 15.0 (maximum) in-lbs to secure the lens on the
niche. DO NOT OVER TIGHTEN THE SCREWS. DO NOT ASSEMBLE
WITH POWER TOOLS. Over tightening or using a motorized screwdriver
on the lens screws can over torque the screw threads and damage the
niche housing and/or lens.
Machine screws
(QTY. 8 - provided)
Lens
O-Ring
Lens cover ring
Rotate lens cover
ring clockwise to
lock in place
To Next Page
Loading...
