Pentair FP0S1300X User Manual

3
FP288 (07-14-20)
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for
personal injury!
DANGER
indicates a hazard which, if not avoided, will
result in death or serious injury.
WARNING
indicates a hazard which, if not avoided,
could result in death or serious injury.
CAUTION
indicates a hazard which, if not avoided, could
result in minor or moderate injury.
NOTICE addresses practices not related to
personalinjury.
Carefully read and follow all safety instructions in this
manual and on the pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
CALIFORNIA PROPOSITION 65 WARNING
WARNING
This product contains chemicals known to
the State of California to cause cancer or birth defects or
other reproductive harm.
1. Know the pump application, limitations, and potential
hazards.
WARNING
Risk of explosion. Do not ground to a gas
supply line. Pump water only with this pump. Failure to
follow this warning can result in personal injury and/or
property damage.
CAUTION
Risk of flooding. Can cause personal injury
and/or property damage. If a flexible discharge hose is
used, make sure pump is secured in sump to prevent
movement. Failure to secure pump may allow pump
movement, switch interference and prevent pump from
starting or stopping.
2. Make certain power source conforms to
requirements of your equipment.
3. Disconnect power before servicing.
4. Release all pressure within system before servicing
any component.
5. Drain all water from system before servicing.
6. Secure discharge line before starting pump. An
unsecured discharge line will whip, possibly causing
personal injury and/or property damage.
7. Check hoses for weak or worn condition before each
use, making certain all connections are secure.
8. Periodically inspect pump and system components.
Keep sump, pump and system free of debris and
foreign objects. Perform routine maintenance as
required.
9. Provide means of pressure relief on pumps whose
discharge line can be shut off or obstructed.
10. Personal Safety:
a. Wear safety glasses at all times when working
with pumps.
b. Keep work area clean, uncluttered and properly
lighted. Replace all unused tools and equipment.
c. Keepvisitorsatasafedistancefromtheworkarea.
d. Make workshop childproof – with padlocks, master
switches, and by removing starter keys.
11. When wiring an electrically driven pump, follow all
electrical and safety codes, as well as most recent
National Electrical Code (NEC) and Occupational
Safety and Health Act (OSHA).
WARNING
Risk of sudden starts. Can cause
electrical shock and personal injury. Pump motor is
equipped with an automatic resetting thermal
protector and may restart unexpectedly.
12.
WARNING
Risk of electric shock. Can shock, burn
or kill. This equipment is only for use on 115 volt (single
phase) and is equipped with an approved 3-conductor
cord and 3-prong, grounding-type plug. Be certain
that it is connected to properly grounded, grounding-
type receptacle. Where a 2-prong wall receptacle
is encountered, it must be replaced with properly
grounded 3-prong receptacle installed in accordance
with the National Electrical Code and local codes and
ordinances.
13. All wiring should be performed by a
qualifiedelectrician.
14. Protect electrical cord from sharp objects,
hot surfaces, oil, and chemicals. Avoid kinking
cord. Replace or repair damaged or worn cords
immediately.
15. Use wire of adequate size to minimize voltage drop at
motor. Refer to most recent National Electrical Code.
16. Do not touch an operating motor. Modern motors are
designed to operate at high temperatures.
17. Do not use in water where fish are present.
SPECIFICATIONS
Power supply required .....................................115V, 60 Hz.
Liquid Temp. Range .................................. Max. 77°F (25°C)
Operation Position .................................................Vertical
Individual Branch Circuit Required ........................ 15 Amp
Operating Depth Beginning min ...................................1/2”
Ending max ..................................... 3/16”
Discharge .................................................... 1” NPT (25 mm)

Pentair FP0S1300X Specifications

General

Brand	Pentair
Model	FP0S1300X
Category	Water Pump
Language	English