EasyManua.ls Logo

Pentair HYPRO 1532C-6ESP-03 - Safety Instructions

Pentair HYPRO 1532C-6ESP-03
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
L-1599 (04-01-22)
SAFETY INSTRUCTIONS
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The word NOTE indicates special instructions that are important
but not related to hazards.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
GENERAL SAFETY
This pump has been specifically equipped
to be compatible with the transfer of diesel fuel. Do
not pump other flammable or explosive fluids such as
gasoline.
Do not use in explosive atmospheres.
The pump should be used only with liquids that are
compatible with the pump component materials.
Failure to follow these Warnings can result in Personal
Injury and/or Property Damage and Will Void the Product
Warranty.
DO NOT EXCEED recommended speed, pressure and
temperature (120 degrees F) for pump and equipment
being used.
BEFORE SERVICING, drain all liquids from the system
and flush. Remove the spark plug wire from the spark
plug before servicing the pump or engine.
Secure the discharge lines before starting the pump. An
unsecured line may whip, causing personal injury and/or
property damage.
Check hose for weak or worn condition before each use.
Make certain that all connections are tight and secure.
Periodically inspect the pump and the system
components. Perform routine maintenance as required
(see Maintenance section).
Protect pump from freezing conditions by draining liquid
and pumping a permanent-type automobile antifreeze
containing a rust inhibitor through the system,
coating the pump interior. A 50% mixture with water is
recommended.
Do not operate a gasoline engine in an enclosed area.
Be sure the area is well ventilated.
Gasoline is a highly combustible fuel. The
improper use, handling, or storage of Gasoline can be
dangerous. Never touch or fill a hot engine.
Use only pipe, hose and fittings rated for the maximum
psi rating of the pump.
Do not use these pumps for pumping water or other
liquids for human or animal consumption.
It is illegal to ship or transport any hazardous chemicals
without United States Environmental Protection Agency
Licensing.
Always drain and flush pumps before servicing or
disassembling for any reason.
Before returning unit for repair, drain out all liquids and
flush unit with neutralizing liquid. Then, drain the pump.,
Attach a tag or include a written notice certifying that
this has been done.
Never store pumps containing hazardous chemicals.

Related product manuals