INTELLIBRITE
®
5G Pool and Spa Lights Installation and User’s Guide
Technical Support: Phone: (800) 831-7133 - Fax: (800) 284-4151
Web sites: www.pentairpool.com and www.staritepool.com:
Contents
IMPORTANT WARNING AND SAFETY INSTRUCTIONS...................................ii
IntelliBrite 5G Pool and Spa Lights Overview ....................................................1
Operating IntelliBrite Pool and Spa lights using a wall switch (12 VAC) ............ 1
Using an External Transformer for Multiple IntelliBrite 12 VAC Light ............. .....1
Powering on IntelliBrite 5G Lights .................................................................... 2
Selecting a light show mode or fixed color ........................................................ 2
Replacing the IntelliBrite 5G Pool and Spa Light Assembly
(in an existing pool/after Electrical Requirements are met) ............................ 3/4
Installing the IntelliBrite 5G Pool and Spa Light Fixture
(new pool construction/ /after Electrical Requirements are met) ) .................. 6/7
IntelliBrite 5G Pool Light (12 V)
Fuse Harness Replacement .......................... 9
Replacing the IntelliBrite 5G Pool Light Circuit Board Assembly
(in an existing pool) .......................................................................................... 9
Wide and Narrow Angle Lens Adjustment........................................................17
IntelliBrite 5G Pool Light Replacement Kit Part Numbers ................................18
Replacing the IntelliBrite Spa Light Face ring and Gasket
(P/N 640045) or Gasket and Lens (640046) ................................................... 19
IntelliBrite 5G Spa Light Replacement Kit Part Numbers ................................ 23
IntelliBrite Color Light Controller ..................................................................... 24
Always install a new lens gasket (see part number in this
User’s Guide on page 9 and 19), when ever reassembling
the light. Failure to do so may permit water to leak into the assembly which
could cause; (a) an electrical hazard resulting in death or serious injury to pool
users, installer, or others due to electrical shock, or (b) breakage of the lamp
or lens, which likewise could result in serious injury to pool user, installers, or
bystanders, or in damage to property.
Before Installing luminaries read the following:
THE INTELLIBRITE 5G LED POOL LIGHT AND
SPA LIGHT CANNOT BE USED ON A DIMMER CIRCUIT. USING
A DIMMER SWITCH WILL RESULT IN PERMANENT DAMAGE TO
THE LIGHT.
P/N 619921 Rev K - 4/2015
FOR 12 VAC LUMINARIES: ALWAYS USE A SEPARATE STEP DOWN
TRANSFORMER TO POWER LUMINARIES. SEE DIAGRAM ON PAGE 7.
Note: Connect all three wires to the corresponding circuit wires in the
Junction Box (black wire to power, white wire to common, and green
wire to ground).
12 VAC LUMINARIES SPECIFICATION: 12 VAC, 50/60 Hz REPLACE ANY CRACKED
PROTECTIVE SHIELD (CRACKED LENS) WITH NEW LENS AND GASKET.
i
To Next Page
Loading...
Need help?
General
