Pentair INTELLIBRITE 5G - Installing the IntelliBrite Spa Light with New Gasket

INTELLIBRITE
®
5G Pool and Spa Lights Installation and User’s Guide
INTELLIBRITE
®
5G Pool and Spa Lights Installation and User’s Guide
7. INSTALLING THE INTELLIBRITE
®
SPA LIGHT WITH NEW GASKET: Install
a new gasket during reassembly of the IntelliBrite spa light. A NEW LENS
GASKET MUST BE USED EACH TIME THE LIGHT IS REASSEMBLED.
8. Install the new gasket onto the lens: With the light housing resting on its
base, place the lens then the gasket on top of the light housing.
9. INSTALL FACE RING: Place the face ring on top of the lens/gasket/housing.
Rotate the light housing to align the “TOP” position arrow indicator label on
the rear of the housing is aligned with the pilot screw on the face ring. Place
the face ring on top of the gasket. Make sure that the lens and gasket are
centered correctly on the light housing.
Pilot screw
s
Align vertical line
on lens to point
to the pilot screw
hole
Align letter “O” in
the word “TOP”
on lens with pilot
screw hole on
face ring
TOP
10. Aligning the face ring and lens: Align the face ring and vertical line on the
lens so that the letter “O” in the word “TOP” and the small arrow above it) on
the surface of the lens points to the 12 O’clock position and with pilot screw
hole on the face ring.
ALIGN
PILOT
SCREW
t
TOP
21