OPERATING THE PUMP 10/20
SET SPEEDS 18 IN SCHEDULE MODE
In schedule mode, speeds 1-8 can be programmed to run a certain speed at a certain time of
day. To run a scheduled speed, press start/stop. The screen will display “Running schedules”
when it is ready to run a scheduled speed. If start/stop is pressed while a scheduled speed is
running, the pump will stop running the scheduled speed. The pump will not continue to run
the scheduled speed until the start/stop button is pressed again.
1. Press menu.
2. Use up or down arrows to scroll to “Speed 1-8”, then press select.
3. Use up or down arrows and press select for the speed you wish to set and schedule.
4. Press select and use the up or down arrows to scroll to “Schedule”. Press save.
5. Press down arrow (“Set speed” will display) and press select to change. Use the up or
down arrow to adjust speed.
6. Press save to save the new speed setting.
7. Press the down arrow again. “Start Time” will display. Press select - the cursor will
highlight the minute column.
8. Use the up or down arrow to change the time and the left or right arrow to move cursor
from minutes to hours.
9. Press save to save the new start time setting.
10. Press down arrow - “Stop Time” will display. Press select.
Repeat Steps 7-8 to set stop time.
11. Press save to save the new stop time setting.
12. Press start/stop.
The IntelliFlo
®
VSD2 Variable Speed Pump will prime and begin to run the programmed
schedule at the specified start time. When running in Schedule or Egg Timer mode, the
countdown time (T 00:01) showing the hours and minutes remaining is displayed.
Programming Schedule for Constant Run
A speed cannot be programmed with the same start and stop times. To run a speed without
stopping, set the Start time one minute after the stop time. Example: A single speed will run
non-stop if programmed with a Start Time of 8:00 AM and a Stop time of 7:59 AM.
Note: The pump will not run the scheduled speeds until the Start/Stop button is pressed
(LED on) to place the pump in Schedule mode.
Note: When two speeds are scheduled during the same run time, the pump will run the
higher RPM Speed regardless of speed # in use.
Note: The most recent command, manual or schedule, takes priority regardless of speed
number RPM.
21
To Next Page
Loading...
Need help?
General
