Pentair KREEPY KRAULY PROWLER 830 - OPERATION; Operating the Cleaner

3
PROWLER
®
820 and 830 Installation and User’s Guide
Float Positions for Brushes (830 Model Only)
Operating the Cleaner
Do not switch the pool cleaner to “ON” if it is not fully immersed in water . Operating the cleaner out of water will
immediately cause severe damage and will result in loss of warranty. Do not leave the cleaner in the pool all the time.
Always remember to turn the power supply “OFF” and unplug it from the power outlet before removing the cleaner
from the pool.
1. Be sure the power supply is positioned at least 10 feet (3 m)
from the pool.
2. Placethecleanerinthewaterasshown.Shakethecleaner
from side to side or turn upside down to release trapped air.
3. PresstheON/OFFbuttontostartthecleaner.Thecleaneris
now ready to begin its cleaning cycle.
4. Thecleanerwillautomaticallyshutoffattheendofits
cleaning cycle.
Placethecableattherightsideinfrontofthehandle.Pulloutonlyoneoat.Thishelpsthecleanerturnin
the pool.
Float position for alternate
cleaning pattern
Pull float out
If brushes are dry, soak in water until soft. The cleaner may not grip
the bottom and walls of the pool as effectively if the brush is dry.
Soak brush before use.
Factory float position
click
click
OPERATION
.
On