Pentair LEGEND - Page 10

LEGEND® INSTALLATION MANUAL
E. Cutting the Feed Hose - (cont.)
8. When cutting hoses, please use strong scissors
or a sharp knife. Be sure to slide the floats out of
the way when cutting hose.
9. Put extra mender nut on the Legend
®
mast and
push clear (soft) hose gently over mast at 1/2",
turn mender nut around clear (soft) hose tight.
Note: The Back-Up Valve still should be 30" from
the head of the cleaner.
10. Now take the bag, EU16, out of the box and firmly
twist lock bag onto the top of Legend
®
throat over
rubber debris valve.
11.Review and check list: White and clear hoses
cut properly and floats evenly spaced. Mender
nuts tight around swivels, Back-Up Valve,
Legend
®
mast and wall fitting. Make sure wall
fitting is securely locked into place.
12. Lower your complete Legend
®
assembly into your
pool carefully. It should look like figure below.
13.Go back to your equipment and turn filter pump
on first (wait 30 seconds to force air out of the
hose), then turn booster pump on.
14.For adding additional feeder hose for large
pools requiring more hose length you will need
to purchase one (1) additional hose (LLD45),
four (4) floats (ED10P), one (1) swivel (ED05),
and two (2) mender nuts (ED15). Attach extra
white (hard) hose between clear (soft) hose and
existing white (hard) hose, using floats, swivel
and mender nuts. Divide extra white (hard) hose
overage by three (3) this time to keep all white
the same length.
6
FEED HOSE
MENDER NUT
FEED MAST
SWIVEL
FIRST
SWIVEL
SECOND
SWIVEL
THIRD
SWIVEL
SHORT
WHITE
HOSE
LONG
WHITE
HOSE
LONG
WHITE
HOSE
BACK UP
VALVE
CLEAR
HOSE