EasyManua.ls Logo

Pentair REBEL 2 - Important Warning and Safety Instructions; Important Notice; Attention Installer; Attention User

Pentair REBEL 2
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
i ii
REBEL™ Suction Side Pool Cleaner Installation and User’s Guide
ii
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
Important Notice:
Attention Installer: This guide contains important information
about the installation, operation and safe use of this product.
This information should be given to the owner and/or operator of
this equipment after installation of the pool cleaner.
Attention User: This manual contains important information
that will help you in operating and maintaining this pool cleaner.
Please retain it for future reference. Consult Pentair with any
questions regarding this equipment.
Before installing this product, read and
follow all warning notices and instructions which are included.
Failure to follow safety warnings and instructions can result
in severe injury, death, or property damage. Call 1300 137 344
for additional free copies of these instructions.
Consumer Information and Safety
This pool cleaner is designed and manufactured to provide
many years of safe and reliable service when installed,
operated and maintained according to the information in this
manual. Throughout the manual, safety warnings and cautions
are identied by the
symbol. Be sure to read and comply
with all of the warnings and cautions.
General Installation Information
Pre-Installation Check List
Before installing your cleaner, review and understand all
warnings and safety information in this guide. Failure to
follow these instructions or improper installation of the
cleaner can result in damage to the pool nish or the vinyl liner,
Pentair Water Pool and Spa, Inc. disclaims any liability for
repairs or replacement to any of these structures or
components of the customer’s pool.
Before installing the cleaner in a vinyl liner pool:
Check liner closely for signs of deterioration or damage
from age, chemicals, pool wall damage, etc. If any damage is
found, have a qualied pool professional make all the necessary
repairs. Also, if there are stones, roots, etc., under the liner,
remove them before installing the cleaner.
Before installing the cleaner in a gunite pool or a pool that is
partially or completely tiled:
Repair loose tiles and tighten any loose light rings.
Before installing the cleaner, clean your lter system:
Make sure you have cleaned the lter, including backwashing,
rinsing, and emptying all baskets. A clean system is necessary
for proper cleaner operation and coverage.
Before installing the cleaner, understand cleaner coverage:
The cleaner is designed to rid your pool of debris in
approximately 4-6 hours. Less time could be needed,
depending on the pool size. The cleaner was not designed to
automatically clean steps or swimouts or to work under a solar
cover. It was also not designed to do initial cleanup for a new
pool or when opening your pool for the season.
AFTER installing the cleaner, make
sure the cleaner is
operating correctly:
The cleaner may need some minor adjustments to make
sure it is operating properly so there is no damage to the
pool nish. Certain vinyl liner patterns are particularly
susceptible to surface wear, pattern removal, ink rubbing off
of, or serious scratches to the pattern caused by objects
coming into contact with the vinyl surface, including
automatic pool cleaners. Pentair Water Pool and Spa, Inc. is
not responsible for any pattern removal, abrasions or markings
on vinyl liners.
HAZARDOUS SUCTION.
Do not play with cleaner or hose or apply to
body. Can trap and tear hair or body parts.
Hose can trip or entangle swimmers which
could result in drowning.
SUCTION ENTRAPMENT, INJURY, AND
DROWNING HAZARD. If your pool has a
dedicated suction port (“vac port”) for
vacuuming or for an automatic pool cleaner,
it must be covered when not in use. A spring
loaded safety cover (a “vac port tting”) is
included with your cleaner. Install it on the
suction port to prevent entrapment and injury.
If the cover provided does not t, purchase one
that does from your local pool store and install
it instead. The cover should conform to IAPMO
SPS4-99A.
Stop pump before attempting to clean
unit. Do not allow swimmers in pool while
pool cleaner is operating.
To reduce the risk of injury, do not let
children use or play with pool cleaner.
Do not allow swimmers in the pool while pool
cleaner is operating. Hose can trip or entangle
swimmers which could result in drowning.
Moving parts may injure hands or ngers.
Stop pump before attempting to clean out
pool cleaner head.
Warnings and safety instructions for Pentair Water Pool and Spa,
Inc. pumps and other related products are available at:
http://www.pentairpool.com/pool-owner/safety-warnings/ or call
(800) 831-7133 for additional free copies of these instructions.
Please refer to http://www.pentairpool.com/pool-owner/
safetywarnings/ for warning and safety instructions related to
this product.
IMPORTANT WARNING & SAFETY INSTRUCTIONS
REBEL
®
2 Automatic Vacuum Pool Cleaner Owner’s Manual
REBEL
®
2 Automatic Vacuum Pool Cleaner Owner’s Manual
REBEL™ Suction Side
Pool Cleaner Installation and User’s Guide
i
If you have questions about ordering Pentair Aquatic Systems replacement parts and pool products, please contact:
CUSTOMER SERVICE / TECHNICAL SUPPORT
Customer Service and Technical Support, Australia
(8 A.M. to 5 P.M. Eastern Standard Time)
Phone: 1300 137 344
Fax: 1800 006 688
Web site
Visit www.pentairpool.com.au
New Zealand
(8 A.M. to 5 P.M.)
Phone: 0800 654 112
Fax: 0800 806 642
TABLE OF CONTENTS
Maintenance ........................................................
Removing Debris from the Turbine
Tire Replacement
Troubleshooting ..................................................
Replacement Parts ............................................
Important Warning and
Safety Instructions ..............................................
Pool Preparation ...................................................
Cleaner Components
Assembling the Cleaner ......................................
Hose Assembly
Installing the Cleaner ...........................................
Standard Installation
Flow Gauge Instructions
Calculating Cleaner Speed [RPM] Without
the Flow Gauge
Cleaner Adjustments and Operation ..................
Hose Length
Eyeball Diverter Positions
ii
1
1
2
2
3
3
4
4
5
5
5
6
6
7
8
9
CUSTOMER SERVICE / TECHNICAL SUPPORT
TABLE OF CONTENTS
REBEL™ Suction Side
Pool Cleaner Installation and User’s Guide
i
If you have questions about ordering Pentair Aquatic Systems replacement parts and pool products, please contact:
CUSTOMER SERVICE / TECHNICAL SUPPORT
Customer Service and Technical Support, Australia
(8 A.M. to 5 P.M. — Eastern Standard Time)
Phone: 1300 137 344
Fax: 1800 006 688
Web site
Visit www.pentairpool.com.au
New Zealand
(8 A.M. to 5 P.M.)
Phone: 0800 654 112
Fax: 0800 806 642
Before installing the cleaner, understand cleaner coverage:
The cleaner is designed to rid your pool over a number of Hours
depending on the size of pool, amount of debris and type of debris.
The cleaner was not designed to automatically clean steps or
swim-outs or to work under a solar cover. It was also not designed
to do initial cleanup for a new pool or when opening your pool for
the season.
Before installing the cleaner, understand normal use:
Normal usage is running the cleaner for around 2 hours per day
repeated use (i.e. every day) or 4-6 hours frequent use (i.e. weekly,
bi-weekly). Based on maintained pool chemistry, correct
installation and normal use, the cleaner and components
should meet or exceed the warranty period.
Wear and tear will occur faster with more frequent use, incorrect
chemistry and abnormal operation and wearable parts may need
to be replaced more frequently, at the expense of the owner.

Related product manuals