Why is there iron in the conditioned water from my Pentair Water Dispenser?
If your Pentair Water Dispenser has iron in the conditioned water, it may be due to a fouled mineral bed. Check the backwash, brine draw, and brine tank fill. Increase the frequency of regeneration and the backwash time.
General| Brand | Pentair |
|---|---|
| Model | SOFTFLO 5600 |
| Category | Water Dispenser |
| Language | English |
Modifications for drain lines that must rise above the control valve.
Measures water usage and regenerates system when capacity is depleted.
Regenerates system after capacity depletion at programmed time.
Regenerates on a timed interval based on programmed regeneration time.
Regenerates on a weekly schedule based on programmed days.
Includes time, entry/exit procedures, and system resets.
Sets display format, valve type, control type, and number of tanks.
Sets the maximum days between regeneration cycles.
Sets the time of day for regeneration.
Enters the feedwater hardness for calculations.
Sets the fixed reserve capacity for the system.
Sets the current day of the week for scheduling.
Displays the current outlet flow rate of the unit.
Shows the highest flow rate measured since the last regeneration.
Displays the total hours the unit has been in service.
Shows the total volume of water treated by the unit.
Displays the system's calculated reserve capacity.
Shows the installed software version on the controller.
Recommended types of salt and substitutes for the softener.
Guidance on the recommended salt level in the brine tank.
Steps for replacing key components of the brine valve and injector assembly.
Detailed instructions for replacing the brine valve component.
Guide for replacing the injector nozzle, throat, and screen.
Procedure for replacing the timer assembly on the control valve.
Instructions for removing and replacing the piston assembly.
Illustrates water flow through the unit during normal service operation.
Shows water flow during the preliminary rinse cycle.
Depicts water flow during the backwash regeneration step.
Illustrates water flow during the brine draw and slow rinse cycle.
Troubleshoots intermittent loss of soft water due to usage, chemistry, or regeneration frequency.
Addresses constant loss of soft water from low salt, high consumption, or dirty screens.
Identifies causes and solutions for brine tank overflow issues.
To Next Page