Pentair STA-RITE MAX-E-PRO P6RA Series - Pump Models and Safety Instructions; Model Identification and Safety Reminder

‘P6RA’, P6EA’ ‘P6E’ and
‘P6R’ SERIES PUMP
WITH TRAP
To avoid unneeded service calls, prevent possible
injuries, and get the most out of your pump, READ THIS
MANUAL CAREFULLY!
The Sta-Rite ‘P6RA’, ‘P6EA’, ‘P6R’ and ‘P6E’ Series
Max-E-Pro
®
High Efficiency Pool and Spa Pumps:
• Are designed for use with swimming pools or as
centrifugal pumps
READ AND FOLLOW
SAFETY INSTRUCTIONS!
Carefully read and follow all safety instructions in this
manual and on equipment. Keep safety labels in good
condition; replace if missing or damaged.
Incorrectly installed or tested equipment may fail,
causing severe injury or property damage.
Read and follow instructions in owner's manual when
installing and operating equipment. Have a trained pool
professional perform all pressure tests.
1. Do not connect system to a high pressure or city
water system.
2. Use equipment only in a pool or spa installation.
3. Install pump with at least two (2) hydraulically
balanced main drains equipped with correctly
installed, screw-fastened, anti-entrapment certified
covers. See Page 3.
4. Trapped air in system can cause separation of pump
components. BE SURE all air is out of system before
operating or testing equipment.
Before pressure testing, make the following safety
checks:
• Check all clamps, bolts, lids, and system accessories
before testing.
• Release all air in system before testing.
• Water pressure for test must be less than 25 PSI
(7.5 kg/cm
2
).
• Water Temperature for test must be less than 100
o
F
(38
o
C).
• Limit test to 24 hours. After test, visually check system
to be sure it is ready for operation. Remove trap lid
and retighten hand tight only.
NOTICE: These parameters apply to Sta-Rite
equipment only. For non-Sta-Rite equipment, consult
manufacturer.
Max-E-Pro Pump Models
Hp
Energy Efficient
Full-Rate
Energy Efficient
Up-Rate
Standard
Full-Rate
Standard
Up-Rate
1/2 P6E6C-204L/ / /
3/4 P6E6D-205L/P6R6D-205L/
1P6E6E-206LP6EA6E-205LP6R6E-206LP6RA6E-205L
1-1/2 P6E6F-207LP6EA6E-206LP6R6F-207LP6RA6F-206L
1-3/4 / P6EAA6F-216L/P6RAA6F-216L
2P6E6G-208LP6EA6G-207LP6R6G-208LP6RA6G-2 07L
2-1/2 / / / P6RAA6G-208L
3P6E6H-209L/P6R6H-209L/
2-Speed
3 Phase
208-230/460v
3 Phase
575v
3 Phase
200/400V
////
//P6EA6D36-204P6R62D3-186
/ 345076P6EA6E36-205P6R62E3-187
P6RA6YF-206L 345077/P6R62F3-188
////
P6RA6YG-207L 345078P6EA6G36-207P6R62G3-189
P6EAA6G-208L/ / /
/ 345079P6E6H36-209/
1
MAX-E-PRO
®
High Efficiency Pool and Spa Pump Installation and User’s Guide