- 11 -
5) Confirm if the touch panel has changed in the next screen as shown in Photo-6 Left.
6) Enter key command “Ctrl+Alt+Contrast enhance” (with the ordinary keyboard, “Ctrl+Alt+F7”) to show
“PASSWORD?” prompt on the CRT monitor (Refer to Photo-7).
7) Answer “PASSWORD?” with the password “excalibur” (Refer to Photo-7). And the page button “<” and
“>” appear on the touch screen (Refer to Photo-6 Right).
Important: Please share the password between the persons only who have been qualified for servicing with the
service training. Please keep it secret to customers.
8) Tap the page button “>” to call “Processor Adjust Menu” on the touch screen (Refer to Photo-8).
9) Tap “Pump Level” button (Refer to Photo-8) to call “Pump Level Adjustment” screen (Refer to
Photo-9).
Photo-6 Jig mode on touch screen
Page buttons
Photo-7 Password operation
To Next Page
Loading...
