77420 - 67/107 -
5-2. AF FI adjustment
[Required equipments]
□AF chart for 2m (No.1 and 2) □AF master lens for 2m
*Set the AF chart for 2m as following condition.
1) Distance between AF chart and camera mount surface: 1,954.5mm
(=1.9545m).
2) Chart should be set at perpendicularly against light axis of the lens.
3) Lighting the chart approx LV11~12 on surface of chart.
If brightness is not enough, adjustment will not be passed (NG)
◆Example for lighting→
AF Chart No.2
①Double click [K-5_FI Ver100.exe] in [K-5_FI Ver100] folder to start up software.
(Following adjusting screen is displayed)
②Input temperature(℃) and press [Enter] key. ((a):Select Celsius or Fahrenheit by cursor)
*In case of NG, there is possibility that the temperature is difference more than 2℃between room
temperature and temperature for inside of camera.
*Adjust the camera after the camera fit in the room temperature.
③When temperature adjustment is completed,
right screen is displayed.→
④Set the camera to AF chartNo.1 (vertical line).
⑤Press [OK] button then start to align the cart position.
⑥If the chart and center of camera are out of alignment, below screen will be displayed.
Align the center by moving camera position. (Match a yellow line with red line.)
＠
②
To Next Page
Loading...
