Pentax Optio 50 - Selecting Metering Mode

EN-36
Selecting the Metering Mode
You can select the metering mode that sets which part of the subject to measure to determine the
exposure.
1. Rotate the mode dial to , , , or and turn your
camera on by pressing the button.
2. Press the MENU button, then use X to select the [Mode2] menu.
3. Use T to select [AE Metering], then press the button.
4. Use S or T to select the desired metering mode, then press the
button.


 [ Center-weight]: Averages the light metered from the
entire frame, but gives greater weight to the subject matter
at the center.


 [ Spot]: The exposure is determined by the small area in
the center of the screen only.
5. To exit the menu, press the MENU button.
6. Compose your subject within the focus frame.
7. Press the shutter button to capture the image.
OK :
Exit :
Mode1 Mode2 Mode3
Focus
Drive Mode
AE Metering
Std.
3 / 3
OK :
Exit :
AE Metering
Center-weight
Spot
1 / 2